Dexaplan VT 623 Manuel d'utilisateur télécharger pdf (Page 19)

GB / IE - 21

Fuse: 250 V,3 A; slow action

Chime: max. 68 dB(A) (at distance of 1 m)

Monitor: 2.5” TFT,colour

Monitor resolution: 640 x 240 pixels

Line-out output: 1 Vpp / 600 Ohm

Dimensions: approx. 100 x 180 x 34 mm incl. wall bracket

Casing material: indoor station: PC, ABS;

Wall bracket: Aluminium

Weight: approx. 306 g incl. wall bracket

Relative humidity: 20 -80 %

Operating temperature: -10 °C to +50 °C

Application: indoor use only

Model: KSAFF1500150W1

Power supply: 100-240 V , 50/60 Hz, 0.6 A

Power output: 15 V , 1.5 A

Application: indoor use only

Wire cross section: 2 x 0.75 mm²

Supplied length: 15 m

Max. length: 75 m (min. 0.75 mm², copper)

The following instructions are provided for your safety and satisfaction

during operation of the device. Note that non-observance of these safety

instructions results in significant risks of accident.

If this point is not heeded life and health is endangered.

Non-observance of these instructions puts property at risk

of damage.

Optimum results will be achieved by observing these instructions.

Do not leave small children unsupervised with the device, packaging

material or small parts. Otherwise there is a risk of fatal injury due to

choking or suffocation.

Perform the connection and installation while the mains power is

disconnected! Otherwise there is a risk of fatal injury due to electric

shock.

Do not damage any gas, electricity, water or telecommunication lines

during drilling and fixing work. Otherwise there are dangers of

personal and fatal injury and fire.

Treat the cables carefully. Lay these so that they cannot be damaged

and do not present any tripping hazard. Fix the cables sufficiently. Do

not pull the cables over sharp edges and do not crush or crimp them

elsewhere. Otherwise there are dangers of personal and fatal injury

and fire.

Do not place the equipment near fire, heat or long lasting high

temperature effects of more than +50 °C. Otherwise there is a risk of

Mains adapter

Connection cable

Safety instructions

Explanation of symbols and terms used:

Danger!

Attention!

Tip:

Danger!

fatal injury due to fire.

Do not connect any external voltage to the connection terminals.

Otherwise there are dangers of personal and fatal injury and fire.

Plug the mains adapter for the mains power connection into the mains

socket completely. Do not touch it with wet hands. Otherwise there is a

risk of fatal injury due to electric shock.

Only operate the indoor station and the mains adapter in dry areas.

Do not expose them to dripping or splash water. Only clean the

equipment with a dry and, if necessary slightly moist, cloth. Do not

submerge the equipment in water. Otherwise there is a risk of fatal

injury due to electric shock and fire.

Do not connect any damaged device (e.g. transport damage) and

disconnect the power supply immediately in the case of damage.

Unplug the mains adapter from the mains socket. Arrange for the

damage to be repaired immediately by a specialist. Otherwise there is

a risk of fatal injury due to electric shock.

Only operate the system with 15 V DC from the supplied power

supply. Before connecting the power supply to the mains, ensure that

the mains current complies with 230 V AC, 50 Hz and is fitted with

a fuse according to local regulations.

Protect the equipment and the cables against strong magnetic or

electrical fields and against strong mechanical loads and vibrations.

Only have repairs carried out by authorised and trained qualified

personnel. Otherwise there is a risk of damage due to improper use

and invalidation of the warranty.

Observe the following points:

Protect the outdoor station as much as possible againstdirect rainfall.

Mount the outdoor station at such a height that visitors can

comfortably reach the doorbell button and that the face of the person

ringing the bell is in the field of view of the camera. Pay attention to

the height of children in doing so. The vertical detection angle of the

camera is approx. 48°.

The outdoor station is usually installed at the side of the entrance

door. Ensure that the face of the visitor standing in front of the door

can be seen on the screen. The horizontal detection angle of the

camera is approx. 64°. If necessary, use the enclosed wedge shaped

bracket to align the outdoor station.

Position the outdoor station so that no direct light falls on the lens

opening. Avoid strong backlighting behind the visitor: in this case, the

person appears darker on the image. Check the camera image before

mounting. Put the unit into operation and hold the outdoor station in

the desired place for this. If necessary, change the position until you

have found the optimum image. Remember that the position of the

sun changes.

Attention!

Planning the installation

Outdoor station:

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 29 30

Commentaires sur ces manuels

Pas de commentaire

Dexaplan VT 623 Manuel d'utilisateur Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la maison Dexaplan VT 623